Novak Eiger Pro 2S/3S Brushless / Brushed Esc W/ 35T Rockstar Brushed Crawler Motor

FEATURES: ESC-
3A BEC module allows 3S LiPo battery usage
Additional motor wire to connect a 10.5 turn or higher brushless
motor for use with 2S LiPo packs
May be used for brushless class racing, crawling (when used with a
Novak crawling brushless motor), or bashing around
Brushless mode includes on-board programming to customize and fine-
tune the feel of the ESC
Compatible with 2-3S LiPo cells and 4-9 cell NiMH batteries (2S only
with brushless motor)
Three throttle modes;
Rock Crawl Mode with adjustable drag brake power
Standard/Basher Mode for normal FWD/BRK
Robotic or Servo Mode for FWD/REV operation only
Four adjustable parameters;
Brake Power/Throttle Mode (5 settings)
Dead Band (5 settings)
Drive Frequency (5 settings)
Voltage Cut-Off
Non-crawling basher mode can be used in any 1/10, 1/12, 1/16, or
1/18 scale application with a 20 turn or higher brushed motor
One-Touch programming interface with four multi-colored status LEDs
6V output for cooling fan or other options such as running lights
Temperature monitoring allows user to check ESC operating temperature
at any time
Thermal overload protection to prevent overheating
Water-resistant case with silicone gasket seal
One touch setup
RoHS compliant
Motor-
High number of turns for excellent torque and long run times
Rebuildable with easily accessible commutator and replaceable brushes
and springs
Stand-up brush design
High-strength ferrite magnet
Dual ball bearings
Direct solder wiring tabs for flexible soldering options
120 day limited warranty through Novak on both components beginning
at date of purchase

INCLUDES: Novak Eiger Pro ESC with Gold Plated Bullet Motor Plugs,
Mounting Tape, Power Cap, Wires, Heat Sink, 3A BEC Module,
Instruction Manual, 35T Rockstar Brushed Motor

REQUIRES: Installing in vehicle and connecting to battery, receiver and motor

SPECS: ESC-
Input Cells: 2-3S LiPo or 4-9 NiMH
Size: 1.15 x 0.95 x 0.75" (29.0 x 24.3 x 20mm)
Weight: 0.75oz. (21.31g) without wires
On-Resistance: 0.00036 ohms
Motor Limit: 2S Brushed, 20T or higher, any 380 size
3S Brushed, 20T, any 380 size
2S Brushless, 10.5T or higher, any 380 size
BEC: 6V DC/3A
Wire Size: 14G Super-Flex Copper-Strand Silicone Wire
Motor-
Input Voltage: 2S LiPo cells or 4-7 cells (1.2V/cell)
Motor Size: 2.07 x 1.42" (52.7 x 36.1mm)
Shaft Diameter: 0.125" (3.2mm) accepts all 1/8" pinion gears
Bearing: Standard 3/8" x 1/8"
Motor Weight: 5.97oz. (169g)