M2C MOTOR SUPPORT

You asked and we delivered! The M2C 3635 MOTOR SUPPORT!

Made from a softer compound plastic, this support tie wraps to your motor and protects your gears and motor mount on hard impacts.

Designed for use with 46-48MM diameter motors, and can be used with any size motor to provide some cushion.

Installation is super easy, just slide it under your motor and make sure you have about 3mm travel when you press down on your motor. (this is to account for chassis flex)

Moving the support closer to the mount will allow for more flex,

While out towards the end of the motor will compensate less.

Install the included tie wrap and go bash!

The bottom of the block at the lowest point is 3.75MM (.150 in) and is 19MM long to spread out the load.

To use this support as intended, you'll need about 7MM between your motor and chassis. (a little double sided tape can close it up a bit if needed)

If you do not leave a gap for chassis flex, this part is not going to work for you. We recommend about 3MM

While it's no earth shattering, revolutionary product, it will surely save some motor mounts and gears.

Includes:

1) M2C 3635 MOTOR SUPPORT

1) BLACK TIE WRAP