M2C GEN 2 ARRMA 8S STEERING BELL CRANK KIT FOR 56118 G2 MOTORS

THIS KIT IS IF YOU DO NOT ALREADY HAVE 3295

NOW CLEARS THE MAX5 G2 COMBO WITH 56118 MOTOR!!!

You will need to install the included flat nut with loctite and grind some clearance as shown. (also shown is why)

You may have to grind some clearance on the stock tie bar nut, this is not necessary, the gain is tiny, but personal preference.

You'll also need to reset your steering endpoints, you actually gain a little max steering to the left with the new geometry.

TOUGH TESTED by the M2C TEST TEAM. This kit has been beat to death with no failures so far.

All parts are made using 7075-t6 Aircraft aluminum. These are high precision machined bearing POCKETS.

Please be patient when inserting bearings.

The best method is to insert the bottom bearing on the shoulder bolt into the pocket. then put the top bearing on the post and let the shoulder bolt align the bearing.

It is advised that you blue lock tight on the shoulder bolts threads when installing the parts.

This model does not use bushings. The 6mm reamed hole will give you full support of the steering arms.

It is also advised that you grease the posts to cut down on friction.

48 grams