M2c ARRMA PILLOW BALL INSERTION WRENCH
This wrench is designed to fit both 6S and 8S models. it is highly advised to purchase this wrench to help prevent cross threading the plastic hubs.
We have all fought the battle of trying to start the pillow ball retainers in the plastic hubs. One wrong turn and it cross threads. As a result of the design of the Arrma 8S hubs , it is especially difficult with the support ribs on the hubs. This tool will allow you to have a super fine feel when starting the pillar ball in the hub.
HOW TO INSTRUCTIONS:
PLACE THE WHITE DELRIN INSERT INTO THE PILLOW BALL RETAINER AND PLACE THE PILLAR BALL NUT ON THE WRENCH
PUT THE PILLOW BALL RETAINER IN THE HUB.
ROTATE THE WRENCH COUNTER CLOCK WISE UNTIL YOU FEEL THE THE PILLOW BALL SLIDE PAST THE FIRST THREAD IN THE HUB.
IT WILL ACTUALLY GO FURTHER INTO THE HUB.
THEN TURN THE WRENCH CLOCK WISE SLOWLY AND SCREW THE PILLOW BALL NUT IN UNTIL YOU FEEL RESISTANCE.
THEN USE THE SUPPLIED (with the kit) 5MM OR 8MM HEX WRENCH TO TIGHTEN THE REST OF THE WAY.
YOU WILL FEEL THE PILLOW BALL RETAINER START TO TIGHTEN UP WITH THE WRENCH AS IT GETS CLOSE TO THE PILLAR BALL
ONCE THE PLASTIC INSERT TOUCHES THE PILLOW BALL, BACK OFF APPROXIMATELY 1/8 TO 3/8 OF A TURN.
THE PILLOW BALL SHOULD FLOAT FREE WITH NO BINDING.
| Part # | M2C 3327 |
|---|---|
| Brand | M2C Racing |