M2C 1101-UP M2C PERFECT MESH UPGRADE KIT

Built to fit X, AND XR SERIES TRUCKS!!

THIS IS THE 1101-UP UPGRADE KIT FOR EVERYBODY OUT THERE WHO ALREADY HAS OUR 1100 OR 1214 MOUNT !!!!!

SETTING YOUR MESH DOESN'T HAVE TO BE A CHORE ANYMORE WITH THE M2C PERFECT MESH SYSTEM!!!!

Even comes with a lanyard so you dont lose it!!!!

1. Set your slide with motor and gear into the mount resting on the spur gear

2. lnstall a side locking screw into the slide LOOSELY. YOU WILL PULL THE ADJUSTER THROUGH AND DAMAGE THE SLIDE IF IT IS NOT LOOSE!!

3. Run the 3483 adjuster screw through the 1228 printed block far enough to reach the slide notch with the ball (notch WILL be tight the first time)

4. Back out the adjuster screw (using the 3mm wrench that came with your truck) until the 1228 locks into the motor mount

5. Back out the adjusting screw until the pinion lifts off the spur, now lower the gear until desired mesh is met.

6. Tighten the screw you loosely installed to lock in your position, and install remaining slide lock screws

7. REMOVE THE 1228 PERFECT MESH BLOCK!!! By simply turning clockwise, it will lift off the top of the mount.

Fits hobbywing 1650kv, 1100kv, and 800kv combos and many others!