Dynamite WP 60A FWD/REV Brushed ESC

Out of stock

This waterproof, brushed ESC is NiMH/LiPo compatible and offers forward/brake/reverse, forward/brake and crawler drive modes. Its compatibility makes it an ideal replacement ESC or the perfect upgrade to your current non-LiPo, non-waterproof, or limited motor spec ESC.


  • Waterproof for all weather operation *
  • LiPo and NiMH compatible
  • Program functions changed with the use of jumper pins
  • Up to an 8T motor limit
  • Removable mounting tabs create an even smaller footprint and allow hard mounting in a wide variety of vehicles
  • Crawler running mode
  • Pre-wired with EC3 battery connector and RTR compatible motor bullets for easy installation


Time Delay Brake:Yes
Continuous Maximum Current:FWD: 60A REV: 30A
Input Voltage:2-3S Lipo, 5-9 cells NiMH/NiCd
Input Connector Types:EC3
Output Connector Types:3.5mm Tamiya style bullet
Motor Limit:2S Lipo/6cell NiMh >=8T 540/550 closed endbell motors, 3S Lipo/9cell NiMh >=13T 540/550 closed endbell motors
Momentary Peak Current:FWD: 360A REV: 180A
Length:1.48 in (37.5mm)
Width:1.46 in (37mm) without tabs, 2.23 in (56.6mm) with tabs
Height:0.71 in (18mm)
Weight:1.41 oz (40g)
BEC Voltage:5V
PWM Frequency:1KHz
Overload Protection:Yes
Full On Resistance:.0008 ohms
Wire Gauge:16AWG
Auto Cutoff:Yes 
* While waterproof, this component has not been designed to immerse in water for long periods of time and should NOT be treated like a submarine. Please be sure to read through the general precautions listed in the user’s manual.   dynamite 60amp
More Information
Part # DYNS2210
Brand Dynamite
Brush Type Brushed
Sensor Type No
Vehicle Type Car