M2C ARRMA KRATON EXB FRONT SHOCK TOWER

Made using 3/8 material (9.5 thick) These towers have been hard bashed by out test team and taken some seriously bad crashes with no ill effect. The square frame approach should add very good support all around the tower and the (stubby ear design) should make it very rigid. We have also added material in center where the part normally bends and added a tapered cut to provide more support at the bottom screw area.

SPECIAL NOTE:::::

No one can build a shock tower that will withstand an upside down landings without a wing . 

It is highly advised that you purchase the part no. 3035 Rear shock tower support brace. this kit anchors the bracing to the center brace and

to the shock tower to give it a very ridged  bracing system.