M2C ARRMA KRATON 6S .2,.3,.4 , V5 & EXB MODEL CHASSIS

On the advise of Of our test team We have redesigned the

rear section of the chassis and added 20 mm more material to cut down on chassis flex. this material is time tested to provide much more rigidity

to the chassis. We have also added Our custom droop screws to the kit , so there will be minimal wear at the droop screw contact points. this newer model is

designed to work with the 2,3,4 and EXB CHASSIS and the stock Arrma parts. I cannot vouch for the other manufactors arms .

NOTE:

FOR THE People USING RPM ARMS. RPM DID NOT PUT THE DROOP SCREW IN THE CORRECT PLACE. NOTHING I CAN DO ABOUT THAT. WHAT CAN BE DONE.

You can simply drill a 1/8 hole to the inside of next to the stock hole in the arm . then simply screw in the supplied droop screw and it will be in the stock location of the 

ARRMA droop screw. it's that simple.

NOTE: THE SMALL WHITE INSERT IS USED WHEN YOU RUN AN AFTERMARKET BUMPER.

BUT IS NOT NEEDED IF YOU RUNG THE STOCK BUMPER.