M2C 3012 6S CARBON ROD END (1mm Wall)

For 10MM ID X 12MM OD Carbon fiber tube. 1MM is the wall thickness. (Carbon tube not included)

THE M2C 3012 CARBON ROD ENDS FOR THE ARRMA 6S LINE OF TRUCKS IS THE SOLUTION!!!!

Bashers have been using these carbon fiber tubes over their braces for years.

I just didn't like the unfinished look, so I came up with a solution that that will clean it up!!

Installation is super easy, just cut your carbon tube to slightly shorter than your brace (1MM recommended).

I have included 2 1MM o rings to take up the slack between the tube and the end.

HAS A 1/8" THRU HOLE IN CASE YOU BREAK THE SCREW, YOU CAN JUST DRILL IT OUT FROM THE FRONT!

PRO TIP!! I have included 2 .5mm shims, you want the ends to be TIGHT.

You want 1/8 to 1/4 of a turn past hand tight and the flats to be in line (use hex drivers as shown in video).

You can use the included shims to achieve this.